A Review on InGaSb Growth under Microgravity and Terrestrial Conditions Towards Future Crystal Growth Project Using Chinese Recovery Satellite SJ-10

The paper reviewed the previous microgravity experiment using Chinese recovery satellite, the in-situ measurement of composition profile in the solution by X-ray penetration method and homogeneous growth of InGaSb by temperature freezing method under terrestrial condition for making clear the effect of gravity on the growth of InGaSb ternary alloy semiconductor crystals. The previous experimental results showed that the shape of solid/liquid interfaces and composition profile in the solution were significantly affected by gravity. Based on the previous microgravity experimental results, experimental conditions were investigated to grow homogeneous In _xGa _1?xSb with higher indium composition at Chinese recovery satellite SJ-10 in near future.     

The Somatropin Reference Standard (Control 951) of the National Institute of Health Sciences

Somatropin material was examined for preparation of the "Somatropin Reference Standard". The candidate material was evaluated by a domestic collaborative study in which eight laboratories participated. The protein content was determined to be 4.5 mg/Vial based on amino acid analysis. Because of the possibility of application as a chemical reference standard for assay by the HPLC method, a physico-chemical evaluation of the candidate material was also performed. By SE-HPLC, the content of polymer, dimer were determined to be 0.54%, 0.98%, respectively. By RP-HPLC, the early peak area ascribed to desamido and sulfoxide form was 1.07% of the total peak area. And for informational data, the potency of the candidate material, being estimated by three different biological methods, weight gain assay, tibia test and adiposeconversion assay is 14.8 IU/vial. Based on the above results, the candidate was authorized as the Somatropin Reference Standard of the National Institute of Health Sciences.     

A dynamically reconfigurable processor for H.264/AVC image prediction

H.264/AVC provides high video quality at substantially low bit rates. It is useful for saving and transferring video images by robot cameras. However, the computational complexity of H.264/AVC is very high. A high-speed general-purpose processor is necessary to process H.264/AVC. However, it is difficult to use such a processor for a portable device. Therefore, an application-specific processor is necessary. A dynamic reconfiguration can virtually expand the circuit area in a limited chip area. Therefore, this article proposes a dynamically reconfigurable processor for H.264/AVC image prediction. H.264/AVC contains intra- and inter-prediction processes. The intra- and inter-prediction processes are not used at the same time. The proposed processor was designed and synthesized, and dynamically reconfigures those circuits. As a result, look-up tables (LUTs) were reduced to 93%, flip-flops were reduced to 94%, and the maximum delay was about the same.     

Experience with radio isotope myelography from neurosurgical aspects (author's transl)

Experience with Radio Isotope Myelography is reported here. 169Yb-DTPA as a tracer was intrathecally injected at lumbar region in twenty three patients with various spinal cord lesions. The first scanning is perfomed after comfirming by gamma-camera that the tracer reaches to the lesion, the second and the third scannings are done according to the ascending rate of the tracer. (I) Normal scintimyelogram (A) In normal case, the shape of the Radio Isotope Myelogram well corresponds the shape of anatomical subarachnoid space. (B) In normal adult cases, the tracer comes up to the cisterna magna in 20-25 minutes after the lumbar injection. Therefore, the scintimyelographic diagnosis should be made not only by the shape but also by the ascending rapidity of the tracer. (II) Abnormal scintimyelogram Abnormal scintimyelograms could be summarized as following three categories. (A) "Delay": It means delay of the ascending of the tracer. Besides, "Transient delay" found in a case of Arnord-Chiari's malformation was proposed. (B) "Partial block": It meas a defect at the level of the lesion. This "Partial block" were observed in cases of spinal cord angioma, cervical spondylosis and spinal cord tumor etc. (C) "Complete block": It means the stagnation of the tracer below the lesion. To sum up, Rario Isotope Myelography, especially in partial block, can more easily and more sensitively represent the maximum extent of the spinal cord lesion than other myelographic study or angiographic one. On the other hand, we can not qualitatively diagnose about the lesions by its indistinct border.     

气体辅助法陶瓷薄膜的制备

Ceramics （alumina） coating on sevaral materials has been successfully achieved at room temperature by gas - assisted deposition （ GAD） technique. In the GAD process the alumina powder was accelerated by jet flow with velocity of - 1000 m/s and impaeted to a substrate, thereby a fiat and dense film was deposited up to 10 μm on the substrate without arty additional heating. The crystal structttre of the alumina in an obtained GAD films seemed as amorphous like. The crystalline phase was recovered by post nnnenling at 1 300 ℃ , however, the matrix resulted in a hollow structure.     

Effect of gravity on InGaSb crystal growth

The effect of gravity on dissolution of GaSb in InSb melt and growth of InGaSb was experimentally investigated. Experiments were carried out in a GaSb(seed)/InSb/GaSb(feed) sandwich system under an imposed temperature gradient. In the experiments, the GaSb feed crystal dissolved into the InSb melt to supply the required GaSb component for the growth of In_0.1Ga_0.9Sb crystal. Two parameters were considered: (1) the inclination angle (θ) of the sample for gravity as 0° and 53°, and (2) the sample diameter (D) as 9 mm and 5mm. When θ was 0°, the interface was almost flat, indicating that convection was axisymmetric and stable. Whereas the interface was distorted towards gravitational direction when θ was 53°, indicating that solutal convection was dominant. The decrease of growth temperature and sample diameter reduced the distortion of interface and the dissolution amount of GaSb feed. The homogeneous crystals were grown at the initial growth stage by supplying the GaSb component during growth.     

Meshless analysis of potential problems in three dimensions with the hybrid boundary node method

Combining a modified functional with the moving least‐squares (MLS) approximation, the hybrid boundary node method (Hybrid BNM) is a truly meshless, boundary‐only method. The method may have advantages from the meshless local boundary integral equation (MLBIE) method and also the boundary node method (BNM). In fact, the Hybrid BNN requires only the discrete nodes located on the surface of the domain. The Hybrid BNM has been applied to solve 2D potential problems. In this paper, the Hybrid BNM is extended to solve potential problems in three dimensions. Formulations of the Hybrid BNM for 3D potential problems and the MLS approximation on a generic surface are developed. A general computer code of the Hybrid BNM is implemented in C++. The main drawback of the ‘boundary layer effect’ in the Hybrid BNM in the 2D case is circumvented by an adaptive face integration scheme. The parameters that influence the performance of this method are studied through three different geometries and known analytical fields. Numerical results for the solution of the 3D Laplace's equation show that high convergence rates with mesh refinement and high accuracy are achievable. Copyright © 2004 John Wiley & Sons, Ltd.     

Intestinal absorption and biological effects of orally administered amorphous silica particles

Although amorphous silica nanoparticles are widely used in the production of food products (e.g., as anticaking agents), there is little information available about their absorption and biological effects after oral exposure. Here, we examined the in vitro intestinal absorption and in vivo biological effects in mice of orally administered amorphous silica particles with diameters of 70, 300, and 1,000 nm (nSP70, mSP300, and mSP1000, respectively) and of nSP70 that had been surface-modified with carboxyl or amine groups (nSP70-C and nSP70-N, respectively). Analysis of intestinal absorption by means of the everted gut sac method combined with an inductively coupled plasma optical emission spectrometer showed that the intestinal absorption of nSP70-C was significantly greater than that of nSP70. The absorption of nSP70-N tended to be greater than that of nSP70; however, the results were not statistically significant. Our results indicate that silica nanoparticles can be absorbed through the intestine and that particle diameter and surface properties are major determinants of the degree of absorption. We also examined the biological effects of the silica particles after 28-day oral exposure in mice. Hematological, histopathological, and biochemical analyses showed no significant differences between control mice and mice treated with the silica particles, suggesting that the silica nanoparticles evaluated in this study are safe for use in food production.     

Attribute-based quality classification of academic papers

Investigating the relevant literature is very important for research activities. However, it is difficult to select the most appropriate and important academic papers from the enormous number of papers published annually. Researchers search paper databases by combining keywords, and then select papers to read using some evaluation measure—often, citation count. However, the citation count of recently published papers tends to be very small because citation count measures accumulated importance. This paper focuses on the possibility of classifying high-quality papers superficially using attributes such as publication year, publisher, and words in the abstract. To examine this idea, we construct classifiers by applying machine-learning algorithms and evaluate these classifiers using cross-validation. The results show that our approach effectively finds high-quality papers.